Krone EasyCut B 970 - Maintenance - after the Season; Maintenance - Once after 50 Hours; Maintenance - Every 10 Hours, but at Least Once a Day

11 Maintenance - General Information
11.1 Maintenance table
66
EasyCut B 970
Original Operating Instructions 150000711_01_en
Components
Tighten screws/nuts refer to page67
Check guard cloths refer to page72
Check the hydraulic hoses for leaks and, if ne-
cessary, have them replaced by a KRONE
service partner.
refer to page73
Check the electrical connection cables and, if
necessary, have them repaired or changed by
a KRONE service partner
Checking/setting all the machine settings Refer to chapter "Settings"
11.1.2 Maintenance – After the season
Components
Clean the machine refer to page72
Lubricate the machine according to the lubric-
ation chart
refer to page90
Lubricate the universal shaft refer to page89
Release the springs
Grease the threads of the setting screws
Grease the uncoated piston rods of all hy-
draulic cylinders and insert as far as possible
Lightly coat with oil all those lever joints and
bearing positions which cannot be lubricated
Touch up damaged paint and preserve un-
coated areas with rust protection agent
Check that all moveable components move
freely. If required, dismount, clean, grease and
remount.
Park the machine in a weatherproof and dry
location which is not in close proximity to cor-
rosive substances
Move the machine every 2 months
11.1.3 Maintenance - Once after 50 hours
Changing oil
Input gearbox refer to page74
Main gearbox refer to page75
11.1.4 Maintenance - Every 10 hours, but at least once a day
Checking oil level
Input gearbox refer to page74
Main gearbox refer to page75
Cutterbar refer to page87