Krone EasyCut B 970 - Mowing

Operation 8
Mowing 8.6
EasyCut B 970
Original Operating Instructions 150000711_01_en 53
Raising both mowers simultaneously from the working position to the headland position
 Move the toggle switch (3) to the “centre” position.
 Actuate the control unit (1+) until both mowers are raised to the headland position.
Moving right mower from the headland position to the working position
 Move the toggle switch (3) to the “left” position.
 Actuate the control unit (2-) until the right mower is lowered to the working position.
 To mow, move the control unit (2-) to the float position.
Moving right mower from the working position to the headland position
 Move the toggle switch (3) to the “left” position.
 Actuate the control unit (2+) until the right mower is raised to the headland position.
Moving left mower from the headland position to the working position
 Move the toggle switch (3) to the “left” position.
 Move the control unit (1+) to the float position until the left mower is lowered to the working
position.
 To mow, move the control unit (1+) to the float position.
Moving left mower from the working position to the headland position
 Move the toggle switch (3) to the “left” position.
 Actuate the control unit (1+) until the left mower is raised to the headland position.
From headland to transport position
ü The PTO drive is switched off.
ü The support jacks have been swivelled into the transport position and locked with the bolts.
 Move machine to headland position,refer to page52.
 Move the toggle switch (2) into "top" position and hold.
 Actuate the double-action control unit (2+) until the mowers are raised from the headland
position to the transport position.
NOTE! To prevent damaging the machine due to an operating error, switch off the operation
panel.
 To switch off the operation panel, move the toggle switch(2) into the "middle" position.
8.6 Mowing
Preparing to mow
ü All points listed in the chapter "Start-up" have been fulfilled, refer to page43.
ü The machine is in the working position, refer to page52.
ü The machine is shut down and safeguarded, refer to page24.
ü The front guards are folded down, refer to page49.
ü The side guards are folded down, refer to page50.
ü The rear linkage is blocked.
ü The parking jacks are in the transport position, refer to page51.