Krone EasyCut B 970 - 10 Settings; Setting the Cutting Height

Settings 10
Setting the cutting height 10.1
EasyCut B 970
Original Operating Instructions 150000711_01_en 59
10 Settings
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page13.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page24.
10.1 Setting the cutting height
KMG000-035
The cutting height is adjusted via the top link(1).
Setting range of cutting height, refer to page35.
ü The support jack/the support jacks are swivelled down, refer to page51.
 Lower the machine up to the support jack/(s).
 Shut down and safeguard the machine, refer to page24.
 Turn the top link until the cutting height is set.
ð Top link longer = greater cutting height
ð Top link shorter = smaller cutting height
 Swivel the support jack/(s) up, refer to page51.
For version with "high-cut skids"
The cutting height can be increased using high-cut skids.