Krone EasyCut B 970 - Maintenance - Every 50 Hours; Maintenance - Every 200 Hours; Tightening Torques

Maintenance - General Information 11
Tightening torques 11.2
EasyCut B 970
Original Operating Instructions 150000711_01_en 67
Components
Change/replace blades refer to page79
Check/replace cutting discs/mower drums refer to page85
Check/change retaining bolts (blade screw
connection)
refer to page82
Check/replace retaining bolts (blade quick
fastener)
refer to page82
Check/change blade carrier (blade quick
fastener)
refer to page83
Check guard cloths refer to page72
Check/replace locking of the side guards refer to page63
11.1.5 Maintenance - Every 50 hours
Components
Tighten screws/nuts refer to page67
11.1.6 Maintenance - Every 200 hours
Changing oil
Input gearbox refer to page74
Main gearbox refer to page75
11.2 Tightening torques
Metric thread screws with control thread
INFORMATION
The table does not apply to countersunk screws with hexagon socket in case the countersunk
screw is tightened via hexagon socket.
DV000-001
X Thread size 1 Strength class on screw head