Krone EasyCut B 970 - Page 64

10 Settings
10.7 Checking/setting locking of side guards
64
EasyCut B 970
Original Operating Instructions 150000711_01_en
The locking (2) prevents during use that the side guard (1) is folded up and foreign bodies are
slung away. Therefore make sure every time before using the machine that the side guard (1) of
the machine is folded down and secured by the locking (2).
Check the lock
 Move the machine to the working position,refer to page52.
ð If the side guard folds down, it is correctly set.
ð If the side guard does not fold down, the locking must be set.
 Move the machine to the transport position.
ð If the side guard folds down, the side guard is correctly adjusted.
ð If the side guard does not fold down, the lock must be adjusted.
Setting the locking
ü The machine is in the working position, refer to page52.
ü The machine is shut down and safeguarded, refer to page24.
 Loosen the screw connection (3).
 Readjust the locking (2) in the oblong hole.
 Tighten the screw connection (3).
 Check the locking (2).