II - 1
Safety
2 Safety
2.1 Identifying Safety Instructions
in the Operating Manual
The safety instructions contained in this manual
which could result in personal injury if not followed
are identified by the general danger sign:
safety sign in accordance with DIN 4844 - W9
General function instructions are indicated as follows:
2.2 Safety Instructions and
Accident Prevent Regulations
2.2.1 Personnel Qualification and Training
Persons who use, service or repair the round baler
must be trained in its use and instructed as to the
risks connected with its operation. The operator must
define spheres of responsibility and monitoring of
personnel. Should personnel lack the required know-
ledge they must receive the required training and
instruction. The operator must ensure that the
contents of this operating manual have been fully
understood by personnel.
Repair work not described in this operating manual
should be completed by authorised service centres
only.
2.2.2 Failure to Follow the Safety
Instructions
Failure to follow the safety instructions could result in
personal injury and environmental hazards as well as
damage to the machine. Failure to follow the safety
instructions could result in the forfeiture of any claims
for damages.
Failure to follow the safety instructions could result,
for example, in the following hazards:
– risk to persons by failure to secure the working
area
– breakdown of important machine functions
– failure of prescribed methods for repair and
maintenance
– risk to persons due to mechanical and chemical
effects
– damage to the environment due to leaking
hydraulic oil
2.2.3 Working in a Safety Conscious
Manner
Follow the safety instructions included in this operating
manual, existing accident prevention rules and any
internal work, operating and safety rules set out by the
operator.
The safety and accident prevention regulations of the
responsible professional associations are binding.
The safety instructions provided by the vehicle manu-
facturer should also be observed.
Instructions which are attached to the machine need
to be followed and kept fully legible.
To Next Page
Loading...
