Krone Round Pack 1250 - Error Messages

VIII - 10
Control unit Comfort
The error message:
- Wrapping process -
-- not catched ! ---
appears on the display screen:
• when the binding or net wrapping process has been
started but does not run correctly.
Cause:
Twine or netting was not fed into the bale chamber by the
baling material during the start procedure.
Remedy:
Continue baling material pick-up, restart the start
procedure by pressing key (0).
See Chapter 11 “Faults - Causes and Remedy”
8.8 STOP Key
Interrupt program sequence:
• press the STOP key (16)
The following appears in the display screen:
----- Program ------
---- stopped ! -----
Restart program sequence:
• Press key (9)
or
• key (19)
8.9 Error Messages
The error message:
- Wrapping process -
-- stand still ! ---
appears on the display screen:
• if the wrapping or binding process starts running and then
stops.
Cause:
wrapping stops netting ripped etc.
Remedy:
See Chapter 11 “Faults - Causes and Remedy”
Prog Quit
#
12 5678 90
34
VP-1-023
9
15
16
STOP
19176
13
----- Program ------
---- stopped ! -----
Prog Quit
#
12 5678 90
34
VP-2-024
0
STOP
- Wrapping process -
-- stand still ! ---
Prog Quit
#
12 5678 90
34
VP-3-024
0
STOP
- Wrapping process -
-- not catched ! ---