VIII - 11
Control unit Comfort
The error message:
- Wrapping process -
---- not cut ! ----
appears on the display screen:
• when the binding or net wrapping process has been
completed but the binding or net wrapping mechanism
continues to run.
Cause:
twine or netting has not been cut.
Remedy:
Eject the round bale. Shut the bale chamber.
Sharpen the blades and check their settings
(see “Maintenance” and Chapter 11 “Faults - Causes and
Remedy”).
8.10 Alarm Messages
The alarm message:
alarm-number:......0
blades not working !
appears on the display screen:
• when the blades have been extended hydraulically or
due to excessively dull blades
The alarm message:
alarm-number:......1
--- Bale chamber ---
------ open ! ------
appears on the display screen:
• when the tailgate is open before the baling process has
been completed
The alarm message:
alarm-number:......2
- Wrapping process -
appears on the display screen:
• if the wrapping system is running during the normal
baling process.
Prog Quit
#
12 5678 90
34
VP-4-024
0
STOP
- Wrapping process -
---- not cut ! ----
#
12 5678 90
34
RP-4-001
STOP
alarm-number:......0
blades not working !
#
12 5678 90
34
RP-4-002
STOP
alarm-number:......1
--- Bale chamber ---
------ open ! ------
#
12 5678 90
34
RP-4-003
3
STOP
alarm-number:......2
- Wrapping process -
17
25
Switch the control box off and on to cut the net.
Remedy:
Check the net wrapping system.
To Next Page
Loading...
