VI - 2
Control unit Basis
6.3 Operation
6.3.1 Actuating the Wrapping
When the desired baling pressure is reached, the wrapping
process should be started.
• Actuate switch (1), and keep it depressed until the bale
has caught the twine and pulls it.
The twine wrapping or wrapping process runs
automatically.
6.2 Preparing for Use
Attach the control unit on the tractor in a place where it is
clearly visible to the driver.
Connect the power supply (12V).
Check for correct polarity!
Switch on the control unit using the ON/OFF
switch (2).
The motor should run in basic setting.
If this is not the case:
1. Check the power supply.
RP600005
1
RP600004
2
To Next Page
Loading...
