VIII - 6
Control unit Comfort
Switch cutting system on or off
(Blade Zero Position)
The cutting system is switched on or off using the
corresponding control valve inside the tractor. If the cutting
system is not longer in working position (blade zero
position) when it is switched off, indicator lamps (17) and
(25) will light up and at the same time the horn will sound.
Switch off the horn by pressing the “alarm off” key.
Suppress the alarm signal by pressing the “alarm off” key
(3) a second time.
Selecting the wrapping start delay
- The presetting of the nominal and the set values appear in
the display for the wrapping start delay.
“Wrapping start delay” means the time
between “preset density reached” and
“start of the wrapping process”.
- Nominal value: value currently stored in the memory.
Reducing set value:
• Actuate key.
Increasing set value:
• Actuate key.
Storing set value as nominal value:
• Actuate key
(Value 1 = 0.8 sec. means: if the effective value is 20,
there will be a delay of 16 seconds.)
#
12 567 8 90
34
STOP
90 90
Prog Quit
17
3
VP100100
Verzögerungzahl 6
Ist-Wert :......... 8
Soll-Wert: ........ 15
weiter.........ja=quit
#
STOP
4
To Next Page
Loading...
