SERVICE SCHEDULE 28
K05N K15A K45A T1A
Wheels Check the chain tension. ( p. 40) • • •
Clean the chain. ( p. 40) • • •
Check the wheel bearing for play. x
• •
Clean and grease adjusting screws of chain adjuster. • • •
K05N: after 500 km (310.7 mi)
K15A: every 1,500 km (932 mi)
K45A: every 4,500 km (2,796 mi)
T1A: daily
7.2Important maintenance work to be carried out by an authorized KTM workshop. (as additional order)
K100A J1A J2A
Carry out a complete fork service. x
• •
Carry out a complete shock absorber service. x
•
Grease the steering head bearing. x
• •
Change the hydraulic clutch fluid. x
• •
Change the crankshaft main bearing. x
•
Change the transmission bearing. x
•
Change the balancer bearing. x
•
Change the timing chain. x
•
Change the shaft seal rings and gaskets. x
•
Check wear of all transmission components including shafts. x
•
Check the crankshaft, connecting rod and cylinder. x
•
Check the clutch. x
•
Check the camshaft, rocker arm and valves. x
•
K100A: every 10,000 km (6,214 mi)
J1A: annually
J2A: every 2 years
7.3Important checks and maintenance work to be carried out by the rider.
NB1A
Check the engine oil level. ( p. 67) •
Check the front brake fluid level. ( p. 43) •
Check the rear brake fluid level. ( p. 47) •
Check the front brake linings. ( p. 44) •
Check the rear brake linings. ( p. 48) •
Check and adjust Bowden cables. •
Bleed fork legs. ( p. 35) •
Clean the chain. ( p. 40) •
Check the chain tension. ( p. 40) •
Check the rear sprocket/engine sprocket for wear. ( p. 41) •
Clean the air filter. x
•
Check the tire air pressure. ( p. 54) •
Check the tire condition. ( p. 53) •
Check the coolant level. ( p. 63) •
Empty the carburetor float chamber. •
Check that all operating elements for smooth operation. •
Check braking. •
Check all screws to see if they are tight. •
NB1A: Depending on conditions of use according to requirements.
To Next Page
Loading...
Need help?
General
