6. Move the loader-control-lever to the dump
position,
and check to see if the stands are folded as
specified.
[A] Good
[B] No good
(A)
Encircled part gets folded
backward into position
(B) Encircled part gets stretched
forward into position
IMPORTANT :
• Keep the
engine off and move the bucket to
the dump position.
NOTE :
• If either of the links gets stuck in the wrong
position, move the bucket back to the full
roll back position and extend the adjusting
bolt at the wrong side by the following
length.
(A) Extend by 1 mm to 2 mm
7. Fasten the seat belt, and start the engine.
8. Move the
loader-control-lever to the dump position
until the hydraulic pressure gets relieved.
9. Lower the boom to put the bucket on the ground
and stop the engine.
(1) Bucket (2) Stand
10. Lift the stand on the right side of the loader up to
the position by hand shown in the following figure.
(1) Stand hook
(2) Stand pin
(A)
Almost the same length
(B) Hold up by hand
11. Reposition
the
adjusting bolt until it touches the
stand.
(1) Adjusting bolt
NOTE :
• The position
of the adjusting bolt is
provisional and may be roughly set for now.
12. Adjust the adjusting bolt in the same way as for the
stand on the left side of the loader.
REINSTALLING THE LOADER
To Next Page
