Venta 3030-3530-4030
54
7. - Putting into service
RN034AGB D
Seed Drill
Hydraulic blower drive
Conditions required
- Connect the hydraulic hose (1) on the blower to a
single acting or double acting valve.
- Connect the hydraulic hose (2) of the blower to a free
return on the tractor. If the tractor is not fitted with a
male connector coupler (2), use the one supplied with
the machine to connect the hose (3) to the tractor's
free return.
• Coupling type: 29 mm 3/4’’, See page
104
Only use tractors equipped with a load
sensing hydraulic circuit.
Only this type of tractor is pre-equipped for
use over a long time period and fitted with
adjustable flow control valves.
In case of doubt, refer to the tractor
operator's manual and contact the official
distributor of the concerned tractor brand.
To Next Page
