KUHN Venta 3030 - Page 6

Venta 3030-3530-4030
4
2. - Contents
RN034AGB D
Seed Drill
8. Instructions for transport ............................................................................................63
8.1 Putting the machine into transport position.................................................................................... 63
8.1.1 Steps................................................................................................................................. 63
8.1.2 Pre-emergence markers (Optional equipment) ................................................................ 64
8.1.3 Radar arm (Optional equipment) ...................................................................................... 64
8.1.4 Metering unit..................................................................................................................... 64
8.1.5 Parallelogram linkage....................................................................................................... 64
8.1.6 Covering harrow ............................................................................................................... 65
8.2 Conformity with the road regulations ............................................................................................. 66
8.3 Machine transport using transport means ..................................................................................... 66
9. Instructions for work....................................................................................................67
9.1 Items to check before starting work ............................................................................................... 67
9.1.1 The application rate .......................................................................................................... 67
9.1.2 The tramlining................................................................................................................... 68
9.2 Putting the machine into work position .......................................................................................... 68
9.2.1 Lower the harrow.............................................................................................................. 69
9.2.2 Lower the radar arm (Optional equipment)....................................................................... 69
9.2.3 Lower the pre-emergence marker (Optional equipment).................................................. 70
9.3 Adjustments in working position..................................................................................................... 71
9.3.1 Coulter bar adjustment .....................................................................................................73
9.3.2 Ground pressure adjustment............................................................................................ 74
9.3.3 Covering harrow adjustment............................................................................................. 74
9.3.4 Filling the hopper.............................................................................................................. 76
9.4 Adjusting the metering unit ............................................................................................................ 78
9.4.1 Blower............................................................................................................................... 78
9.4.2 Agitator ............................................................................................................................. 80
9.4.3 Adjusting the metering unit opening for large seeds (Large grooves) .............................. 81
9.4.4 Adjusting the metering unit opening for small seeds (Small grooves).............................. 82
9.4.5 Stationary calibration test ................................................................................................. 84
9.5 Machine use .................................................................................................................................. 87
9.6 Emptying the hopper...................................................................................................................... 88
9.6.1 Partial emptying (a) .......................................................................................................... 88
9.6.2 Cleaning the metering unit (b) .......................................................................................... 89
9.7 Uncoupling the machine ................................................................................................................ 90
9.7.1 Parking without soil preparation tool................................................................................. 90
9.7.2 Parking the combination ................................................................................................... 93
