Kyocera 1650

Copier Functions
1-10
Original Orientation
You must specify the orientation of the original when using the following functions: duplex copying,
split copying (from 2-sided originals), margin mode, border erase mode, combine copying, auto
selection mode (optional), and staple copying (optional).
When the originals are set on the platen:
When the originals are set in the document processor:
Note You can change the default setting of the orientation of the original. (See Original Orientation on
page 3-18.)
1
Press the Function key.
2
Press the S key or the T key to select Orig.
direction.
3
Press the Enter key.
4
Press the S key or the T key to select Rear [Back
Edge] or Left top [Left].
5
Press the Enter key.
Original Rear Left top
Original Rear Left top
Continuous scan
Function:
End
Orig. direction : Rear
: Off
Orig. direction:
Rear
Left top
*