Kyocera 1650

Copier Functions
1-32
Program Function
Up to eight combinations of copy modes and functions displayed on the operation panel can be
registered as a single program.
Registering a Program
1
Set the desired copy modes, etc., to be registered.
2
Press the Program key.
3
Press the S key or the T key to select Register
program.
4
Press the Enter key.
5
Press the S key or the T key to select the program
number to register (1 to 8).
Note You can also select the program number using a numeric key.
6
Press the Enter key. The program is registered.
Using a Program to Make Copies
1
Press the Program key.
2
Press the S key or the T key to select the program
number to recall.
Note You can also select the program number using a numeric key.
3
Press the Enter key.
4
Set the originals and press the Start key. Copying starts with the settings that were registered.
Register program.
Program:
Program #7
Program #8
Program #3
Register program:
Program #1
Program #2
Program #3
Program:
Program #1
Program #2