6-35
Operation Panel
EcoPrint (Selecting the EcoPrint mode)
By enabling EcoPrint mode, you can minimize the amount of toner used during printing. Because images printed in this
mode may be slightly coarser than those printed in standard resolution, you should use EcoPrint for test prints or other
situations where high-quality prints are not required.
Use the procedure below to select EcoPrint mode. The default setting is Off.
1 In the Print Quality menu, press U or V to select EcoPrint.
2 Press [OK]. The EcoPrint screen appears.
3 Press U or V to select the EcoPrint mode.
4 Press [OK]. The EcoPrint mode is set and the Print Quality
menu screen reappears.
Toner SaveLevel (Selecting the Toner SaveLevel)
Select the default Toner SaveLevel. One of five levels [1] - [5] can be set.
1 In the Print Quality menu, press U or V to select Toner Save
Level.
2 Press [OK]. The Toner Save Level screen appears.
3 Press U or V to select the Toner SaveLevel mode.
4 Press [OK]. The Toner SaveLevel mode is set and the Print
Quality menu screen reappears.
Gloss Mode (Setting gloss mode)
This feature can be used to set the glossiness of printed matter.
1 In the Print Quality menu, press U or V to select Gloss Mode.
2 Press [OK]. The Gloss Mode screen appears.
3 Press U or V to select whether Gloss Mode is enabled.
4 Press [OK]. The Gloss mode is set and the Print Quality menu
screen reappears.
EcoPrint:
a
b
********************-
2
On
1
*Off
Note Raising the level reduces toner consumption, but image quality falls.
Toner Save Level:
a
b
********************-
2
2
3
3
1
*1(Low)
Gloss Mode:
a
b
********************-
2
On
1
*Off
To Next Page
Loading...
Need help?
General