Operation Panel
6-100
User Login
This switches the User Login Administration On/Off and sets the authentication network server.
1 In the User Login Set. menu, press U or V to select User Login.
2 Press [OK]. The User Login menu screen appears.
Login Type (Enabling of User Login Administration)
Select Netwk Authentic. to enable User Login Administration.
1 In the User Login menu, press U or V to select Login Type.
2 Press [OK]. The Login Type screen appears.
3 Press U or V to select Netwk Authentic. or Off.
4 Press [OK]. The User Login menu reappears.
Netwk Auth. Set (Netwk authentication setting)
Set the network authentication server.
1 In the User Login menu, press U or V to select Netwk Auth. Set.
2 Press [OK]. The Netwk Auth. Set menu screen appears.
The options available in Netwk Auth. Set are as follows:
• Server Type (Server type selection)...6-101
• Host Name (Entering of Host Name)...6-101
• Port (Port number setting)...6-101
• Domain Name (Entering of Domain Name)...6-102
User Login:
a
b
********************-
[ Exit ]
1
Login Type
Note When Netwk Authentic. is selected, set the
network authentication server.
Login Type:
a
b
********************-
2
Netwk Authentic.
1
*Off
Note These settings are only displayed when Netwk Authentic. has been set as the Login Type (Enabling of
User Login Administration) on page 6-100.
Netwk Auth. Set:
a
b
********************-
2
Host Name
3
Domain Name
[ Exit ]
1
Server Type
To Next Page
Loading...
