6-119
Operation Panel
Adjust/Maint. (Adjust/Maintenance selection/setting)
Adjust/Maintenance is used to adjust the print quality and to carry out printer maintenance.
The options available in Adjust/Maintenance are as follows:
• ColorCalib.Cycle (Automatic color adjustment cycle setting)...6-119
• ColorCalibration...6-120
• Color Regist. (Color registration [Standard])...6-120
• Color Regist. (Color registration [Detailed])...6-123
• Restart (Restart Printer)...6-127
• Service Setting (for Maintenance)...6-128
1 Press [Menu].
2 Press U or V to select Adjust/Maint..
3 Press [OK]. The Adjust/Maint. menu appears showing a list of
available options.
ColorCalib.Cycle (Automatic color adjustment cycle setting)
The cycle for automatic execution of color calibration can be selected. The following cycles can be set:
1 In the Adjust/Maint. menu screen, press U or V to select
ColorCalib.Cycle.
2 Press [OK]. The ColorCalib.Cycle screen appears.
3 Press U or V to select the color adjustment cycle.
4 Press [OK]. The color adjustment cycle is set and the Adjust/
Maint. menu screen reappears.
IMPORTANT Service Setting is primarily a menu used by service personnel for maintenance work. There is no
need for customers to use this menu.
Adjust/Maint.:
a
b
********************-
2
ColorCalibration
3
Color Regist.
[ Exit ]
1
ColorCalib.Cycle
Auto Automatic judging and adjustment.
Short Gives priority to image quality. The color adjustment cycle is shorter
than Standard.
Standard Gives equal priority to image quality and printing processing.
Long Gives priority to printing processing. The color adjustment cycle is
longer than Standard.
ColorCalib.Cycle:
a
b
********************-
2
Short
3
Standard
[ Exit ]
1
*Auto
To Next Page
Loading...
Need help?
General