Kyocera FS-1028MFP - Page 334

Default Setting (System Menu)
8-142 OPERATION GUIDE
6 Press the OK key. Secure Protocol appears.
7 Press the U or V key to select [LDAP Security].
8 Press the OK key. LDAP Security appears.
9 Press the U or V key to select [Off], [LDAPv3/TLS]
or [LDAP over SSL].
10 Press the OK key. Completed. is displayed and the
screen returns to the Secure Protocol menu.
SNMPv3 Setting
Sets up SNMPv3. The default setting is Off. Use the procedure below.
Refer to Protocol Detail on page 8-134 about the procedures.
Secure Protocol: a b
2 IPP Security
3 HTTP Security
*********************
[ Exit ]
4 LDAP Security
LDAP Security: a b
*********************
2 LDAPv3/TLS
3 LDAP over SSL
1 *Off