Kyocera FS-1028MFP - Page 335

Default Setting (System Menu)
OPERATION GUIDE 8-143
8
IPSec Setting
Make this setting when you use IPSec. The default setting is On and that of Rule Setting is also Off.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [IPSec].
6 Press the OK key. IPSec appears.
7 Press the U or V key to select [On] or [Off].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
4 WSD-SCAN
5 WSD-PRINT
*********************
[ Exit ]
6 IPSec
IPSec: a b
*********************
2 On
1 *Off