COMMAND CENTER Pages
Specifies the name of the printing system in the AppleTalk network.
Zone Name
Specifies the name of the AppleTalk zone (network). An asterisk (*) means
the default zone.
Advanced > Protocols > NetBEUI
Peer-to-peer printing is available using NetBEUI protocol. With this method, the
printing system is located in Windows Network Neighborhood.
NetBEUI Protocol
Enables or disables NetBEUI protocol. If NetBEUI is turned On, name
resolution via NetBIOS (NMB) can be used.
Printer Name
Printer Name correlates with Host Name in the TCP/IP General page (Refer
to Advanced > Protocols > TCP/IP > General on page 3-35). If you want to
change the NetBEUI printer name, change the TCP/IP Host Name.
Workgroup
Workgroup represents the workgroup which will appear in Entire Network in
Windows Network Neighborhood.
Comment
You can enter comments here. (This can also be left blank.)
Advanced > E-mail > SMTP > General
This machine can send Low Toner and other information via E-mail to the
specified mail address. To use the mail function, configure SMTP (Simple Mail
Transfer Protocol) to connect this machine to an E-mail server.
SMTP Protocol
Enables or disables SMTP protocol. To use E-mail, this protocol must be
enabled.
SMTP Port Number
Set the SMTP Port Number or use the SMTP default port 25.
SMTP Server Name
Enter the SMTP server name or its IP address. If entering the name, rather
than the IP address, a DNS server address must also be configured. The
DNS server address may be entered on the TCP/IP General page (refer to
Advanced > Protocols > TCP/IP > General on page 3-35).
SMTP Server Timeout
Sets the timeout in seconds during which this machine tries to connect to the
SMTP server.
Authentication Protocol
Enables or disables the SMTP authentication protocol or sets POP before
SMTP as the protocol. The SMTP authentication supports Microsoft
Exchange 2000.
Authenticate as
Specifies the user to be authenticated in SMTP authentication. When POP3
User 1 to 3 (Refer to Advanced > E-mail > POP3 > User # on page 3-43) and
i-FAX User are set, you can select one of them. If you want to select a
different user, select Other and enter the login account name and login
password for authentication.
User Guide
3-41
To Next Page
Loading...
Need help?
General