COMMAND CENTER Pages
• Add Paper
• Low Toner
• Add Toner
• Cover Open
• Paper Jam
• All Other Errors
Event Report Interval
Enter the E-mail interval. An E-mail will be sent at the end of the interval only
when at least one of the selected error conditions has occurred during the
interval. The interval can be set from 1 minute to 10000 minutes.
Scheduled Report Items
Check one or more items from Printer Status, Network Status, and
Counter Status.
Scheduled Report Interval
Select the time or interval for sending the status information.
• None: No report is sent.
• Monthly: Sends on the specified time of specified month.
• Weekly: Sends on the specified time of every week.
• Daily: Sends at the specified time of every day.
• Hourly: Sends at the specified interval every hour.
If a specified day does not exist in the month, such as the 31st, the last day
of the month is used as the specified day.
Run once now
You can test this by clicking the Send button to immediately send a report.
Advanced > E-mail > POP3 > General
To use the E-mail function, you need to connect the printing system to an E-mail
server using the POP3 protocol.
POP3 Protocol
Enables or disables POP3 protocol.
Check Interval
Checks E-mails in POP3 server at specific interval. Specify the interval in the
range from 3 minutes to 60 minutes. The default is 15 minutes.
Run once now
Click the Receive button to immediately receive E-mail from the POP3
server.
Domain Restriction
Enter the domain names that can be permitted or rejected. You can also
specify the E-mail addresses.
Advanced > E-mail > POP3 > User #
This page allows you to set the POP3 user account and information on the
POP3 server. Up to three users can be set.
User Profile #
User Guide
3-43
To Next Page
Loading...
Need help?
General