COMMAND CENTER Pages
2
Click Add and specify group information and Permit or Prohibit.
3
Click Submit.
Editing a Group
1
Click Group Authorization Set., open the Group Authorization Set page.
2
Click the desired Group ID or Group Name to edit the group and modify their
information.
3
Click Submit.
Deleting a Group
1
Click Group Authorization Set., open the Group Authorization Set. page.
2
Check the desired group. When the check box on the left side of Group ID is
selected, all groups displayed on the page will be checked.
3
Click Delete. The Group Authorization Set.-Delete page appears. You can
confirm the groups to delete.
4
Click Delete when the desired groups are selected.
Advanced > Management > IC-Card Settings
This feature is available when an optional IC card reader is installed with the
printing system. This enables reading an IC card (FeliCa®) to login the printing
system.
IC Card Read Type
Selects either IDM or FeliCa® type for the IC card to use.
System Code, Service Code, Number of User Blocks to Use
These items are used when FeliCa is selected in IC Card Read Type. Each
item must be given a specific parameter for the FeliCa IC card to use.
Advanced > Management > Notification/Maintenance >
Maintenance Notification
This feature defines the recipient of maintenance information reports.
Equipment ID
This is the name by which the machine will be identified.
Recipient Address
The E-mail address of the recipient. If there is more than one recipient then
the addresses should be separated by a semicolon ";".
Subject
You can include model name, serial number, MAC address and equipment
ID in the subject line as follows: Enter one of the following conversion strings
starting with %. The string will be converted into a pre-defined string to
display the above information.
User Guide
3-49
To Next Page
Loading...
Need help?
General