Kyocera KM-2550

2FT-1
1-3-1
1-3 Installatio n
1-3-1 Unpacking and installation
(1) Installation procedure
Unpacking.
Install the optional paper feeder.
Remove the tapes and pins.
Install the optional original cover or DP.
Connect the connector of the drawer heater.
Connect the power cord.
Load paper.
Make test copies.
Output an own-status report
(maintenance item U000).
Exit maintenance mode.
Start
Install the toner container.
Installing the toner
(maintenance item U130).
Install the optional duplex unit.
Install the optional finisher or job separator.
End of installation.