2FT
1-3-9
1-3-4 Installing the DP (option)
<Procedure>
1. Remove the original holder and remove the
two screws from the rear top cover.
2. Pass the two pins through the screw holes
of the rear top cover and attach them to the
lower frame.
Figure 1-3-10
3. Place the DP on the MFP by fitting the pins
into the holes at the hinge sections of the
DP and sliding them toward the front side.
Figure 1-3-11
4. Secure the DP with the two TP Taptite chro-
mate screws M4 x 10 and the two screws
that have been removed in step 1.
Figure 1-3-12
Screw
Screw
Pin
Pin
Pin
Hole Hole
Pin
DP
Screw
TP Taptite
chromate
screw M4 x 10
TP Taptite
chromate
screw M4 x 10
Screw
DP
To Next Page
Loading...
