Kyocera KM-2550

2FT
1-3-35
1-3-10 Installing the fax system (option)
<Procedure>
Install the optional Memory module DIMM (32MB).
1. Remove the two connectors of the fax con-
trol PCB assembly.
2. Remove the three screws and remove the
mounting plate and the ground wire.
Figure 1-3-65
3. Insert the memory module DIMM at an
angle into the memory slot so that the notch
of the memory DIMM is positioned to the
projection of the memory slot on the fax con-
trol PCB assembly. (1)
4. Push the free end of the module down
toward the board. (2)
5. Attach the mounting plate and the ground
wire that have been removed by Procedure
2 with the three screws to their original posi-
tions.
6. Connect the two connectors that have been
removed by Procedure 1.
Figure 1-3-66
Screws
Fax control PCB assembly
Mounting plate
Connectors
Ground wire
Memory module DIMM
Notch
Memory module DIMM
Memory module DIMM
Memory slot
Memory slot
Projection
Memory slot
Fax control PCB assembly