Kyocera KM-2550

2FT
1-3-44
Install the shield cover.
5. Insert the lower part of the shield cover that
has been removed by Procedure 1 into the
shield box and refit it to its original position
using the six screws (a).
If the fax system is installed, refit the shield
cover using the six screws (a) and screw (b)
to its original position.
Figure 1-3-89
Screw (a)
Shield cover
Screws (a)
Screw (b)
Screw (a)
Screw (a)
Lower part
Shield box