Device Manager
Refresh
Printing device information, such as counters and toner levels, are automatically
updated according to the polling schedule. At any time, you can manually
update this information by clicking Refresh. This may take a few minutes.
Select All
Click Select All to select all displayed printing devices. As an example, it would
support Polling and SNMP Communications settings for all printing devices at
once. Select All selects the devices currently displayed. As an example, this
setting would support changing Polling and SNMP Communications settings for
all printing devices at once. To display additional devices, click one of the
navigation buttons.
Open Device Home Page
Click Open Device Home Page to open the printing device's Home Page (older
Kyocera models), Command Center (newer Kyocera models), or the home
page of another manufacturer's device. This page lets you view detailed device
information and change select device settings from your computer.
Status Filter
You can set a filter that lets you view only the devices in a group that match a
user-selected status. The options for selecting status filter settings are:
No Status Filter
The option displays all devices.
Ready
The device is ready to use.
Warning
The device toner is low.
The device paper is low.
Critical
There is a paper jam in the device.
The device cover is open.
The device toner is empty.
The device is offline.
The device is in Needs Attention mode.
Not connected
The device is not connected.
Any Alerts
Displays all devices that are Critical, Warning, or Not Connected.
Printing
The device is printing.
Upgrading
The device firmware is being upgraded.
User Guide
3-14
To Next Page
Loading...
Need help?
General
