Device Manager
do not match, an Authorization failure message will be recorded for that device
in the fwuplog.txt log file.
Confirm Upgrade Settings
The Confirm Upgrade Settings page shows you a summary of the settings
you have chosen for the firmware upgrade, before the upgrade begins.
Group
The group name for the collection of devices that will be upgraded together.
For single device upgrades, the IP address appears here.
Model
The printer model being upgraded. Model should match the Confirm
Selected Firmware page. For IB-2x, Model should be, for example, Any with
an IB-21E.
Type
The firmware type for the upgrade. Type should match the Confirm
Selected Firmware page. For IB-2x, Type should be, for example, IB-21E
Network Interface.
Retain firmware file
Shows whether you chose to keep the firmware file on your local system
after the firmware upgrade. The Retain firmware file line item appears only
if the Enter URL or Select file from local client option was selected in the
Select Firmware File page.
Version control
Shows whether you chose to allow downgrades if the selected firmware file
is a lower version. This line item appears only if one or more devices have a
higher firmware version.
Simultaneous upgrades
Shows the number of devices in the group that will be upgraded at the same
time. This line item does not appear for single device upgrades.
Port number
Shows the port number to be used to communicate with devices during the
upgrade. This line item only appears for upgrades using WiseCore, Device
Manager 2-32 KMnet Admin OneCPU, or models using the new firmware
format (WiseCore 2 or later).
Retry Interval
Shows the number of minutes before the process will again attempt to
upgrade any devices it was not able to upgrade on the previous try.
Number of retries
Shows the number of retries the process will make to again attempt to
upgrade any devices it was not able to upgrade on the previous try.
Review the summary of settings for accuracy and completeness. If there is
anything in the settings you want to change, click Back and return to the page
of your choice. If you want to start the wizard over from the beginning and
reenter settings, click Cancel. If the summary of settings looks correct and you
want to continue with the upgrade wizard, click Next.
Begin the Firmware Upgrade
If there are any the settings you want to change, click Back and return to the
page of your choice. If you want to start the wizard over from the beginning and
KMnet Admin 2.0
3-23
To Next Page
Loading...
Need help?
General
