2WA/2NJ/2RK
6-159
Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a
working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct print-
ing occurs.
Execution
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
setting: Adj Memory
1.Change the setting value by using [+] [-] key or the numeric keypad.
* :Set the values below in case print failure occurs with the memory shortage. (recommended
value)
Image : +100
* :The work area for copy is small and it may cause output failure if the values are large.
2.Press the [Start] key. Set the setting value.
3.Turn the power switch off then on. Wait more than 5 seconds between the power off and on.
Setting: Adj Max Job
1.Change the setting value by using [+] [-] key or the numeric keypad.
* :The maximum [Printer] jobs should be (maximum jobs) – (maximum copy jobs).
2.Press the [Start] key. Set the setting value.
U340 Setting the applied mode
(Message: Set Applied Mode)
Items Contents
Adj Memory Sets the memory allocation
Adj Max Job Setting the maximum of multiple jobs
Adj Custom Box Set the partition size of Custom Box
Adj Hypas Application Set the partition size of Hypas Application
Items Contents Setting
range
Initial setting
Image Area temporarily used to create output image. -100 to
100(MB)
0
Items Contents Setting
range
Initial setting
Copy Maximum copy (Scan To Print) Jobs 10 to 50 10
Printer Maximum printer (Host To Print) Jobs 10 to 50 -
To Next Page
Loading...
