USER’S MANUAL OF LK-330E
LABEL & MARK INDUSTRIES COMPANY
21
2.3.8 Power switch
Upon power on, the machine will emits a “De---” sound and the following power-on screen
will be displayed. At this time, the cutter dynamo will initialize. Then, the machine will
display the text edit window.
Automatic power off
To save power and to extend its service life, if the machine has been idle for 10 minutes
while powered on without any operation, the automatic power off function will be
performed. A machine in automatic power off mode has no response at all. To cancel this
mode, switch off the power and power on again 3 seconds later.
[Attention]
A machine in automatic power off mode still consumes a little energy. Therefore, be sure to
switch off the power supply if the machine is to be idle for a long time.
Replacement of the cutter
Take off the cutter to be replaced and install a new cutter.
Note:
Be careful not to cut your finger when replacing cutter and anvil.
If a new cutter does not produce the desired performance, please replace the anvil by
appeal the sale agents.
L-MARK
Note:
Do not switch on and off the machine repeatedly.
Power on the machine several seconds after it is being
switched off. Do not switch on the machine
immediately after it is switched off, otherwise miss
operation or data loss may result!
To Next Page
Loading...
