L-Mark LK-330E - Shift]; Revise

USER’S MANUAL OF LK-330E
LABEL & MARK INDUSTRIES COMPANY
50
Note:
 Deleted characters can not be recovered.
4.2.29 [Shift]
Shift key.
4.2.30 Revise
This function is provided to test and correct printing length. And this function is
provided to adjustment the position of the printerhead and cutter.
 Due to ambient temperature variance or material difference by
different manufactures, the actual printed page length may be a little
different from what you have specified.
If you find a large discrepancy between the actual printed page length with
what you have specified, this function helps you to adjust so that the printed
length coincide with the specified length.
 When you print label or flat heat shrink tube you may want print in the center of
vertical. You can use function to do it.
 Sometime when you select auto-length but the page can not be placed in the
middle of two cuter line, you can use this function to adjust the position of cutter
line.
Under the tube medium
Press [Revise] and the screen will display as follows:
Choose Tube Length , make sure the tube is loaded properly, and press [Enter] to start
printing; Then, you may inspect the printing effect of your tube printer.
Tube Length
Cutter +0.0