USER’S MANUAL OF LK-330E
LABEL & MARK INDUSTRIES COMPANY
51
Cutter Adjustment
Choose Cutter +0.0 , then sent -2.0~+5.0 can to adjust the position of cutter line.
Under the Label medium
Press [Revise] and the screen will display as follows:
Length Adjustment
Choose Label Length ,make sure the label is loaded properly, and press [Enter] to
start printing;
When completing printing, the machine will display as follows:
Then, you may inspect the printing effect of your tube printer.
For example:
If the measured total length of these four printings is 101.5mm, you just enter “101.5”
and then press [Enter].
With this function, it is possible to adjust the actually printed length to what you have
specified.
Printerhead position Adjustment
Choose Header_Pos -1.0 and the screen will display as follows:
Label Length
Header_Pos -1.0
Cutter +0.0
Total length of Printings:
Actual length:
To Next Page
Loading...
