USER’S MANUAL OF LK-330E
LABEL & MARK INDUSTRIES COMPANY
47
Adjust half-cut depth of tube
Select Cut depth of tube and press [Enter], then the screen will display as follows:
Use [→] or [← ]to make your selection and press [Enter] to finish sleeve tube
semi-cutting depth. Cutting depth ascends from -3 to +3.
If you have chosen a semi-depth of +3 but are not satisfactory with the semi-cutting
results, then you may need to replace your cutter assembly.
Adjust full-cut depth
Select Full-cut depth and press [Enter] to finish your full cutting depth setting.
The cutting depth ascends from -3 to +3.
¾ If you have selectd the label after press [half-cut depth] and the screen will
display as follows:
Adjust half-cut depth of label
Select Cut depth of label and press [Enter] to finish your label semi-cutting depth.
The cutting depth ascends from -3 to +3.
If you have chosen a semi-depth of +3 but are not satisfactory with the semi-cutting
results, then you may need to replace your cutter assembly.
Adjust full-cut depth
Select Full-cut depth and press [Enter] to finish your full cutting depth setting.
half-cut depth of tube:
-3 -2 -1 0 1 2 3
Cut depth of label
Full-cut depth
To Next Page
Loading...
