86
Appendix D: Quick Chart Reference
This product uses only LED direct drive lighting. Do NOT install fluorescent bulbs.
1. The primary serial tag is on the lower right edge of the front dress panel. The secondary serial tag
is located on the front of the electronics module on the top right side of the cabinet. The first two
digits of the serial number are the year of production; the next two are the month. The next 5 digits
are the sequence of production, and the letter following the serial number is the revision level of
the cabinet.
2. Each motor must be programmed by Labconco for the appropriate width cabinet.
3. THIS PRODUCT USES DIRECT DRIVE T8 LED LAMPS INSTEAD OF FLUORESCENT LAMPS.
THERE IS NO BALLAST; LINE VOLTAGE IS SUPPLIED TO THE LAMP SOCKETS.
To Previous Page
Loading...
Need help?
General
