Product Service 1-800-522-7658
Section Five – Certification Procedures for the Logic+
Accessing the Certifier’s Menu 70
Adjusting the Blower Speed 70
Logic+ Filter Life Gauge Operation and Resetting for Local Conditions 71
Adjusting the Optional Inflow and Downflow Values 72
Type A HEPA Filter Leak Test Information 72
If the Logic+ is contaminated 72
Type A HEPA Filter Leak Test Specifications 73
If the Logic+ is uncontaminated 74
Type A Supply HEPA Filter Leak Test 75-76
Type A Exhaust HEPA Filter Leak Test 77-78
Type B HEPA Filter Leak Test Information 79
Type B Supply HEPA Filter Leak Test 79-82
Type B Exhaust HEPA Filter Leak Test 83-84
Downflow Velocities 85-86
Inflow Velocity Calculation
Primary Inflow Method 86-87
Secondary Inflow Method 88-91
Type B2 Total Exhaust Volume 92
Type B2 Exhaust (Inflow) Alarm Set point 92
Work Area Air Cleanliness Test (optional) 93
Fluorescent Light Level (optional) 94
Noise Level (optional) 94
Vibration (optional) 95
UV intensity (optional) 95
Ground Fault Circuit Interrupter 96
Section Six – Logic+ Service Operations
Recommended Tools for Service 97
External Dress Components
Front Dress Panel Removal and Installation 97-98
Side Panel Removal 98
Side Panel Installation 98
Corner Post Lower Trim 99
Sash Operation/Adjustment 100
Sash Position Switches
Sash Closure Position Switch 101-102
Sash Operating Position Switch 101-102
Sash Cable Retainer 103
Type A Exhaust Damper Adjustment 103
Type A Exhaust Damper Seal Installation 104
Type A HEPA Filter Replacement
Exhaust HEPA Filter Replacement 105-07
Supply HEPA Filter Replacement 108-10
Type B2 Exhaust Damper Adjustment 110
Type B2 Prefilter Replacement 111
Type B2 HEPA Filter Replacement 111-13
Motor/Blower Replacement 114-15
Work Surface Removal 116
Grille Removal 116
Towel Catch Removal 117
Diffuser Removal 118-19
Preparing the Logic for Gaseous Sterilization 120
Section Seven –Electrical System Service Operations
To Next Page
Loading...
Need help?
General
