Lagler Flip - Page 10

FLIP
®
01.01.2019
English / Englisch
HAZARD WARNINGS AND SAFETY INSTRUCTIONS
2
RISK OF FIRE from the overheating of the cables.
• Only cables with two wires and wire cross-sections of at
least 1.5 mm² (0.0023 sq.in.) may be used as motor cables!
• Only cables with two or three wires and wire cross-sections
of at least 1.5 mm² (0.0023 sq.in.) may be used as power
cables!
• The maximum cable length in order to connect the machine
to the mains supply must not exceed 20 m (790”)!
HEALTH RISK caused by dust:
• Make sure that the dust bag is properly fastened to the
machine!
• Do not use damaged, washed or repaired dust bags!
• Do not work with an overfilled dust bag (
Section 5.3,
Emptying the dust bag)!
• If the machine is operated correctly, the mandatory dust
emission values will not be exceeded! When emptying the
dust bag, it is advisable to wear a respiratory protective mask
(at least filter class P2)!
• Always wear a respiratory protective mask (at least filter
class P2) when executing works which might create dust,
e.g. cleaning of the machine!
WARNING!
10