Lagler Flip - Page 9

FLIP
®
01.01.2019
English / Englisch
RISK OF EXPLOSION due to sparks while sanding or a high dust
concentration in the air:
• Do not use the machine near
- sources of fires,
- flammable liquids or gases,
- potentially explosive areas!
• Do not smoke in a dusty environment, e.g. while sanding,
emptying the dust bag or cleaning the machine!
RISK OF FIRE from sparks while sanding or from spontaneous
combustion:
• Prior to sanding a nailed or screwed floor all nails or screws
must be countersunk deeply enough so that they cannot be
sanded:
- Countersink the nails for example with a hammer and a
punch!
- Tighten the screws!
• There is a high risk of fire when sanding woods with a large
amount of resin, oiled or waxed floors or metal! Therefore,
the machine must always be cleaned carefully directly
after sanding! Be certain to note the warning notices of the
manufacturers of paint, oil and wax!
• Cloths, pads, et cetera which have been immersed in oil or
wax can spontaneously combust! Be certain to note the
warning notices of the manufacturers of paint, oil and wax!
• The dust bag must always be removed from the
machine directly after sanding and emptied into a
waste bag with the emptying fixture! Dispose of these
waste bags in a non-combustible container! Cover this
container with a non-combustible cover and be certain
to store it outdoors in non-combustible environment
( Section 5.3, Emptying the dust bag)!
• Always transport and store used dust bags in closed and
non-combustible containers!
• Always transport and store the machine without dust bag!
HAZARD WARNINGS AND SAFETY INSTRUCTIONS
2
WARNING!
9