lancer TP30 - Installation; Unpacking the Dispenser

8
INSTALLATION
Read This Manual
This manual was developed by Lancer Worldwide as a reference guide for the owner/operator and installer
of this dispenser. Please read this manual before installation and operation of this dispenser. Please see
Troubleshooting section for service assistance. If the service cannot be corrected please call your Service
Agent or Lancer Customer Service. Always have your model and serial number available when you call.
Unpacking the Dispenser
1. Set shipping carton upright on the floor then cut package
banding straps and remove.
2. Open top of carton and remove interior packaging.
3. Lift carton up and off of the unit.
Inspect unit for concealed damage. If evident, notify
delivering carrier and file a claim against the same.
NOTE
If unit is to be transported, it is advisable to leave the
unit secured to the plywood shipping base.
NOTE
NSF listed units must be sealed to the counter or use
legs provided.
NOTE
4. Remove plywood shipping base from unit by moving unit so
that one side is off the countertop or table allowing access
to screws on the bottom of the plywood shipping base.
5. Remove accessory kit and loose parts from ice
compartment.
6. Clean ice chute and ice bin using cleaning solution on page
33.
7. If leg kit has been provided, assemble legs by tilting unit.
Never energize the machine if there is any trace of
damage. Contact Lancer Customer Service for
assistance.
! WARNING
Inspectez l’appareil pour déceler des dommages cachés.
Si l’appareil est endommagé, avisez le transporteur et
soumettez-lui une réclamation.
REMARQUE
N’alimentez jamais la machine s’il y a une trace
quelconque de dommage. Contactez le service à la
clientèle de Lancer pour obtenir de l’aide.
! AVERTISSEMENT
Si l’appareil doit être transporté, il est conseillé de le
laisser fixé sur la base d’expédition en contreplaqué.
REMARQUE
Les appareils homologués par la NSF doivent être scellés
sur le comptoir ou reposer sur les pieds fournis.
REMARQUE
NEW COUCHEZ PAS L’APPAREIL SUR LE CÔTÉ OU
SUR LE DOS.
! ATTENTION
DO NOT LAY UNIT ON ITS SIDE OR BACK.
! ATTENTION