5-16 System 824 Training Manual 2/19/98
Step 1 To modify the “Timer Mode”, press u or
d to highlight the “Timer Mode” field.
“Block Mode” is used when you
want to gather data for one single
measurement period that could span
seconds, minutes, or even days. (uses
Run Date, Stop Date, Run Time 1,
and Stop Time 1)
“1/Day” is used when you want to
collect data during a single daily
time period, for several sequential
days. (uses Run Date, Stop Date,
Run Time 1, and Stop Time 1)
“2/Day” is used when you want to
collect data during a two separate
daily time periods, for several
sequential days. (uses Run Date,
Stop Date, Run Time 1, Stop Time 1,
Run Time 2, and Stop Time 2)
Step 2 Press r to enter the “Timer Mode” modifi-
cation field.
Step 3 Use d or u to highlight the desired Timer
Mode selection.
To Next Page
Loading...
