Larson Davis System 824 - Modifying the SLM Settings

6-4 System 824 Training Manual 2/19/98
Here we see the Leq and SEL values,
with the total run time for the cur-
rent measurement.
Step 7 Press r to see the “SLM Current-e” screen.
Step 8 Press r to return to the “SLM Current-a”
screen.
Modifying the SLM Settings
This section applies to both the current and overall
SLM of the 824, since you cannot have independent
settings for each. To change the settings for the SLM,
you can either go to the SETUP menu by pressing S,
or you can take a shortcut from where you are now.
For this exercise, use the shortcut.
Step 1 From within the “SLM Current” window,
press c.
You are now viewing the SLM setting screen. From
here, you can modify the various parameters associ-