6-10 System 824 Training Manual 2/19/98
Step 4 Press r to return to the “SLM Stats-a”
screen.
Modifying the STAT Settings
To change the settings for the Event (Exceedance)
Thresholds, you can either go to the SETUP menu by
pressing S , or you can take the shortcut from where
you are now. Let’s do the shortcut.
From this “Event Counting”
screen, you can modify the different
settings associated with the SLM
Stats screens for the SLM and Peak
detectors that you just viewed. These
are the values that if exceeded or sur-
passed, will be counted and shown.
You can set two exceedance levels for
the SPL detector, and two exceedance
levels for the Peak detector.
Step 1 From within the “SLM Stats” window, press
c.
Step 2 For this exercise, change the Peak 1 level.
Press d until “Pk-1 Excd Lvl” is high-
lighted.
To Next Page
Loading...
