6-2 System 824 Training Manual 2/19/98
Step 4 Next, press VIEW V to access the different
measurement viewing choices for the Log
option.
We have already seen and used the “SLM” and “Any
Data” View modes from the standard SSA setup. Let’s
now look at the “Current SLM” View.
Current SLM
Step 1 Press d to highlight the Current SLM selec-
tion.
In this display, you will see a graphic
time history of the measured sound
pressure, along with a “real-time”
digital numeric readout of the sound
pressure level. The associated setup
parameters (detector rate and
weighting), and run time are also
shown. It should be noted that “Cur-
rent” means the data since the last
RESET R.
Step 2 Press c to accept this View choice. The “SLM
Current-a” screen is now active as is noted at
the top of the display.
If the 824 is not currently running, press RUN/STOP
s to start a measurement.
To Next Page
Loading...
