LaserMech FiberCUT ST - Page 5

PLMNL0199 REV. J Effective Date: 08/05/21 iv FiberCUT
®
ST Operation Manual
3.6 Interface Example ............................................................................................................................. 12
3.7 Ethernet Interface (P3) ..................................................................................................................... 13
3.7.1 Simulating Inputs (i1 – i8) .............................................................................................. 13
3.7.2 Simulate Analog Input (anlg) ......................................................................................... 13
3.7.3 Output Status (MG @OUT[n]) ....................................................................................... 14
3.7.4 Temperature Status (MG tmp1, tmp2, tmp3) ................................................................ 14
3.7.5 Inquire Analog Height Sense (MG @AN[1]) ................................................................. 14
3.7.6 Inquire Analog Head Position (MG @AN[2]) ................................................................. 14
3.7.7 Unsolicited Fault Status................................................................................................. 14
3.8 Head-Control Cable (P4) .................................................................................................................. 15
3.9 Remote I/O Options .......................................................................................................................... 15
3.9.1 EtherNet/IP .................................................................................................................... 16
3.9.2 DeviceNet ...................................................................................................................... 17
3.9.3 Profibus ......................................................................................................................... 18
3.9.4 PROFINET .................................................................................................................... 19
4 Operation ......................................................................................................................................................... 20
4.1 Power Up .......................................................................................................................................... 20
4.2 Sequence of Operation ..................................................................................................................... 20
4.3 Special Case – Starting Off the Part ................................................................................................. 23
4.4 Centering the Laser through the Tip ................................................................................................. 23
4.4.1 Centering the Beam in the Tip Orifice Manually ........................................................... 23
4.4.2 Centering the Beam Using the Camera System ........................................................... 24
4.5 Setting Focus to Tip Distance ........................................................................................................... 27
5 FiberCUT
®
Monitor .......................................................................................................................................... 30
5.1 Installation ......................................................................................................................................... 30
5.2 System Requirements ...................................................................................................................... 30
5.3 Preparing to Connect ........................................................................................................................ 30
5.4 Standard View ................................................................................................................................... 31
5.4.1 Connecting .................................................................................................................... 31
5.4.2 Displays ......................................................................................................................... 32
5.4.3 Status and Fault Code History ...................................................................................... 32