Lauda Variocool VC 1200 - Page 95

Cleaning condenser (air-cooled) ............. 70
Displaying serial numbers ...................61
Disposal (packaging) ...................... 81
Disposal (refrigerant) ..................... 81
Draining .............................. 79
Draining the condenser (water-cooled) .........80
Filling ................................34
Placement ............................ 23
Read out memory ....................... 60
Request data .......................... 60
Retrieving status ..................... 58, 59
Structure ............................. 16
Switching on ........................... 39
Unpacking .............................13
Display
Actual bath temperature ...................40
Basic window (set-up) .................... 40
Expanded status display (set-up) ............. 40
Soft key bar ........................... 40
Status display (set-up) .................... 40
Display buttons
Operation ............................. 18
Displaying serial numbers (device) ............... 61
Disposal
Packaging ............................. 81
Refrigerant ............................ 81
Disposing of refrigerant ...................... 81
Drain tap (position) ......................... 17
Draining
Condenser (water-cooled) ................. 80
Device ............................... 79
Draining nozzle (position) ..................... 17
E
EMC ................................... 8
Entry window
Inputting value ..........................42
Selecting options ........................ 42
Structure ............................. 42
Error ...................................73
Read out memory ....................... 60
Errors .................................. 73
Establishing power supply ..................... 31
Evaporator ............................... 19
Expanded status display (display) ................40
External consuming unit
connect .............................. 26
External control
Activating .............................46
Specifying the set point oset ............... 46
F
Factory Setting
Restore ........................... 58, 59
Factory settings (internal actual temperature)
Restoring ............................. 58
Fill level alarm level ......................... 55
Filler nozzle (position) ........................16
Filling .................................. 34
Flow pressure .............................86
Flow rate ................................86
G
Gain factor .............................. 52
GWP .................................. 85
H
Heat transfer liquid
Checking ............................. 72
Overview (approved) ..................... 30
Removing ............................. 79
Hold-back time ........................... 50
Hose clips ............................... 25
Hoses .................................. 25
I
Input button (position) ....................... 18
Insulation ................................89
Intended Use .............................. 8
Interfaces
Overview ..............................21
Interfaces (position) .........................16
K
Kpe ....................................52
V08
Variocool 95 / 97