Output ports: solenoid 1 (SV1) and solenoid 2 (SV2)
Output type: adjustable duty cycle square wave
Drag the SV1 PWM slider to change the output duty cycle of SV1. Drag the SV1
FREQ slider to change the output frequency of SV1.
Drag the SV2 PWM slider to change the output duty cycle of SV2. Drag the SV2
FREQ slider to change the output frequency of SV2.
*Remarks: In the menu, adjust the duty cycle of SV1/SV2 to 100%. Select the waveform
of the corresponding channel as square wave in the customization, set the frequency
to 10HZ, duty cycle to 10%, and amplitude to 5V. (The independent ignition module is a
modular actuator, which requires the solenoid port and the sensor port to be used at
the same time. Other modular actuators can refer to it.)
4.2.2 Idle Speed Motor
Wiring mode:
Line 1: SV1 +
Line 2: SV2 +
Line 3: SV2 -
Line 4: SV1 -
*Remarks: This is a coil actuator.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
To Next Page
Loading...
