Launch X-431 - Frequency Modulation

LAUNCH X-431 Module S2 User Manual
22
Drag the CH1 amplitude slider to change the output waveform amplitude.
Drag the CH1 frequency slider to change the output waveform frequency to
simulate idle speed and acceleration status.
5) Knock sensor
Output channel: CH1
Output type: shockwave
Drag the CH1 PEAK slider to change the output waveform amplitude to simulate
the magnitude of vibration.
Drag the CH1 FREQ slider to change the output waveform frequency to simulate
the speed of vibration.
3.2.3 Frequency Modulation
*Remarks: The following waveform is a sample waveform, not the actual output
waveform. Users can refer to it to change the frequency to achieve the function.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu