4.
Actuator
4.1 Connection
This function is used to output PWM signals to drive the vehicle-mounted coil
actuator to work, and check the working status to confirm the quality of the
actuator.
The following connections are required for detecting the function:
1)
Connect the sensor module to the diagnostic tool via the USB cable (refer
to Chapter 2.1).
2)
According to the specific application and actuator type, connect as follows
(*Note: when performing the actuator function, ensure that the hardware output
channel of the sensor module is 7-pin interface.)
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
To Next Page
Loading...
