Launch X-431 User Manual

LAUNCH X-431 Module S2 User Manual
3
2 V/Ω/C Multimeter measuring terminal
3
Power button
Press this button to start up and shut
down.
4
B-type USB interface
It is connected to the diagnostic device
via a USB cable.
5 Battery status indicator
lamp (green)
If the green lamp is steady on, the
battery electric quantity is normal. If the
green lamp is flashing at an
intermediate speed, the electric
quantity is low (regardless of whether
the red lamp flashes). If the green lamp
is flashing at a low speed, charging is
in progress.
6 Connection status
indicator lamp (red)
 If the red lamp is steady on, the
diagnostic tool is connected. If the
red lamp is flashing, the diagnostic
tool is disconnected.
 It will enter the charging status only
when the red lamp is flashing. The
green lamp is flashing at a low
speed during charging (if the
electric quantity is full, it will stay
on).
7
CH2
Channel 2
8
CH1
Channel 1
Used to connect 7-pin interface (to six
4mm safety banana head lines) to
9
7-pin interface
measure the actuator. When
measuring the actuator, it is necessary
to connect the module to the car
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu

Launch X-431 Specifications

General

Operating System	Android
RAM	2GB
Processor	Quad-core
Storage	16GB
Battery	Rechargeable lithium-ion
Connectivity	Wi-Fi, Bluetooth
Diagnostic Functions	coding
Special Functions	Oil reset, EPB reset
Software Updates	Online updates
Supported Protocols	CAN
Languages	Multiple languages